|
|||||||||||||||
This page gives More Technical information about Cables to use when installing the Multimedia Wall plates.
More Information > Multimedia Plate Cables
Assuming you have 5 metres between the two plates, these are the products and pages for the cables required to install a set ot two multimedia wall plates.
Scart
NX-SCT-025 which is a basic cable or NX-SCT-205 professional series cable.
http://www.nexxia.co.uk/Audio_Video_Cables/scart_leads.htm
HDMI
NX-HDMI-205 in the Quality range which is a good cable.
The connector does come straight back in the wall plate but you can also use adaptor NX-HDMI-028 to connect the cable from underneath. You can still use a 35mm deep back box even with this adaptor installed.
http://www.nexxia.co.uk/Audio_Connectors/hdmi_adaptors.htm
Use these adaptors below to turn HDMI and optical through 90 degree.
Optical Adaptor
NX-OPT-047
A right angled optical adaptor is now available if installing in a solid wall, this will plug straight in and allow the connection to turn 90 degrees such that the plate can be installed in a smaller back box.
http://www.nexxia.co.uk/Audio_Connectors/Optical_Adaptors.htm
RGB
At the moment we don't have RGB cable off the reel so a recommended lead is NX-RGB-205. Again loose end connectors and solder to sockets. Centre core of the cable goes to the center pin and screening to tab washer on the side.
http://www.nexxia.co.uk/Audio_Video_Cables/rgb_phono_leads.htm
Audio
NX-CB-001, twin core audio cable cut off the reel so just requires soldering same as RGB connections, centre core of the cable goes to the center pin and screening to tab washer on the side
http://www.nexxia.co.uk/Audio_Video_Cables/Cables.htm
S-video
NX-CB-009 again cable off the reel on the above page, wiring diagram available below.
http://www.nexxia.co.uk/More_Information/S-Video_wiring_diagram.htm
For more information, please e-mail Technical@nexxia.co.uk
Copyright
© 2004 Nexxia Designs Limited. All rights reserved.
Revised: January 19, 2008