~Installation Advice - Audi Harness adaptors



\| Home \| Products \| About Nexxia \| News \| Contact \| Terms \| Feedback \| Cancel Order \| "What you need" \| Basket \|Search \| Links \|

Installation Tip - Audi Harness Adaptors

This page gives installation advice about how Audi Harness Adaptor leads work for installation of head units. It also shows how to identify if Bose system is installed in the car or not. Even Non-Bose systems still have rear amplified speaker systems.

All Prices include Vat        -      Fast Delivery        -         Full Technical Back up        -        Europe and International Orders Welcome

Fascia Adaptors for installation of a standard ISO Car Radio.

Fascia Adaptors

Car Stereo Harness Adaptors to install a radio with ISO connections
Harness Adaptors

Steering control Interface leads for installation of a new Radio.

Steering Adaptors

Antenna adaptor to install new Head unit with DIN, ISO or Fakra connection.
Antenna Adaptors

Installation Advice > Audi Harness Adaptors



                Non-Bose                                                                    Bose System

When installing Car Stereo Fitting Kits for Non-Bose systems, using PC9-401, PC9-408 or PC9-409, the lead needs to be adapted to allow switching on of the original fitted Amplifier.

All Audi's using these leads have active rear speakers, built into the speaker themselves. These adaptors convert the New head unit Speaker level output to line level output for the active speakers. These leads feed into the Red Mini ISO plug.

The blue & White wire on the Red mini ISO plug also needs to be connected to the Blue wire coming off of the New Head Unit (marked Amp Remote). At the same time the blue wire on the PC5-90 adaptor also needs connecting to the Blue wire off the New Head Unit.

To do this cut the blue wire between the two Black ISO connectors half way along. Plug the blue & white lead supplied with the red crimp connector on the end into the bullet connector from the Red Mini ISO plug.

Cut the blue wire from the PC5-90 half way along. After stripping, feed both the blue from the PC5-90, and the blue coming from black ISO connector which will plug into the New head unit (not the car end) into the Red Crimp connector. Crimp the connector using proper crimping tool.

Once complete both the PC5-90 and Red & White wire on the mini ISO connector should be getting +12V from the new head unit.

This will power the antenna adaptor and also signal the remote amplifier to switch on.

Also note if your new head unit has RCA outputs with an output above 2.2v, you could use PC9-404 or PC9-410. Installation is the same as above accept the RCA connectors replace the speaker connectors.

Beware that we have recently come across issues of slight interference when using PC9-410 with the latest high powered Alpine and Pioneer head units, in this case use PC9-408.

For more information, please e-mail Technical@nexxia.co.uk

Nexxia Audio Solutions is the trading name owned by Nexxia Designs Limited registered in England and Wales No. 3788559.